Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+======LDT HSI-88 RS232======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[english|Content]] -> [[english#command_stations|Command Stations]] ->   **LDT**
+  * **[[:hsi88-en|HSI-88 RS232]]** | [[:inter10-en|INTER-10]]
+ \\
+^  The HSI-88 USB is not supported!  ^
+|  [[tams:zeus-en|Check for alternatives like Tams Zeus.]]  |
+ \\
+ \\
+{{ hsi-88.jpg?200}}
+=====Setup=====
+{{:hsi88:hsi88-setup-en.png}}\\
+ \\
+=====Interface ID=====
+Mostly the HSI-88 is used as a second interface for sensor reading only. Therefore it is necessary to set the **iid** attribute to link sensors in the plan xml file which is described in chapter [[multicontrollers-fr|Multiple Controllers]].
+ \\
+=====Device=====
+The HSI-88 comes with a 9 pin serial cable, and is as far as known wired "1 to 1".
+If your computer does not feature a serial device you can use an __**[[:usb-rs232-en|recommended USB to RS232 converter]]**__ which ist mostly mapped as "**/dev/ttyUSB0**" under Linux and as "**COM3**" or "**COM4**" under Windows.
+ \\
+=====S88 Chain=====
+Number of **16-Port** modules connected on each chain. \\
+**Note:**\\
+The first address of the first module of each chain immediately follows the last address of the last defined module of the previous string. \\
+This also applies if fewer modules are actually connected than are defined.
+> ** Example: ** \\ If three modules are defined for the first/left chain, their last address is = 48 \\ For the second/middle chain, the first address = 49
+ \\
+=====Options=====
+====Delay====
+If activated the sensor reports low first after the delay timing to avoid unwanted events cause by bad contact of wheels.\\
+The delay timer will be set again to this value if it was high within this timing.\\
+The max. is 2000ms which is also advised and used in other sensor reporting devices.\\
+====CTS====
+Option for DIY compatible devices to disable hardware handshake.\\
+ \\
+=====Links=====
+  * Protocol: {{hsi88:hsi88_befehlssatz.pdf}}