no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== Option Switches ======
+[[:english#interfaces|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[:english|Content]] -> [[:english#command_stations|Command Stations]] -> **[[:loconet-en| Digitrax LocoNet]]**
+   * [[:loconet-cs-en|Command Stations]] | [[:loconet-interfaces-en|Interfaces]] | [[:lnfc-en|Fast Clock]] | [[:loconet-dev-en|Throttles]] | **[[loconet:dtopsw-en|Option Switches]]** | [[:locont-wi-en|Wiring]] | [[:loconet:transponding-en|Transponding]]
+// \\ // \\
+Digitrax uses **Option Switches** to setup stationary decoders. They can be set by standard switch commands or with special LocoNet commands.\\
+Rocrail supports with this dialog reading and writing of Option Switches for the following decoders:
+  * **BDL16x**: current sensors and transponder receiver
+  * **DS64**: switches
+  * **SE8**: switches and signals
+ \\
+| The target decoder must be set in programming mode before option switches can be changed; See manual. |\\
+ \\
+===== Option Switches Dialog =====
+{{:loconet:dtopswdlg-en.png}}\\
+ \\
+==== Address ====
+This is the board address of the decoder.\\
+This address cannot be changed with this dialog, you need to check the manual for this.\\
+ \\
+==== Type ====
+Select the wanted board type to program.\\
+ \\
+==== Option Switches List ====
+Each board type has its own set of option switches as is listed after type selection.\\
+ \\
+==== Read All ====
+Read all the option switches from the address and type set for the board.\\
+ \\
+==== Write All ====
+Write all the option switches from the address and type set for the board.\\