no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== Transponding ======
+[[:english#interfaces|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[:english|Content]] -> [[:english#command_stations|Command Stations]] -> **[[:loconet-en| Digitrax LocoNet]]**
+   * [[:loconet-cs-en|Command Stations]] | [[:loconet-interfaces-en|Interfaces]] | [[:lnfc-en|Fast Clock]] | [[:loconet-dev-en|Throttles]] | [[:locont-wi-en|Wiring]]
+// \\ // \\
+===== Transponding & Rocrail =====
+Transponding can be ordered to the same category as Lissy and RailCom but uses another technique.\\
+ \\
+With the basic transponding decoders the following info is received by Rocrail:
+  * decoder address
+  * BDL168 board number
+  * zone A, B, C, D, E, F, G or H
+ \\
+More advanced transponding decoders can supply also:
+  * operations mode readback of decoder CVs
+  * information about the speed and other status data
+  * surround sound system support
+ \\
+ \\
+===== Addressing =====
+To avoid conflicts with the current sense addressing bus 2 is used for the transponder receivers.\\
+So if the board address is set to **1** the first transponder receiver will report in Rocrail with address **2-1**, and the first sensor with address **0-1**. (bus-address)\\
+The BDL168 transponder addresses increment by 2, not 1.  This means with board address 2 that Zone A is 1, Zone B is 3, etc.  See this table:\\
+ \\
+^ Board 1 RX's ^^^
+^ Zone ^ Bus ^ Address ^
+| A | 1 | 1 |
+| B | 1 | 3 |
+| C | 1 | 5 |
+| D | 1 | 7 |
+| E | 1 | 9 |
+| F | 1 | 11 |
+| G | 1 | 13 |
+| H | 1 | 15 | \\
+ \\
+=====Recommended settings=====
+==== BDL168 ====
+| OPSW9   | Closed (No message sent if un-powered) |
+| OPSW36 | Closed (Ignore GPON) |
+| OPSW37 | Closed (Long delay for sensors) |
+| OPSW38 | Closed (Extra long delay for sensors) |
+| OPSW39 | Closed (Verbose mode enabled) |
+| OPSW42 | Closed (Respond also to first interrogate command) |
+| OPSW43 | Thrown (Filter for transponding enabled) |
+| OPSW44 | Closed (Extra filter for transponding) |
+| OPSW45 | Closed (Don't send transponding messages at GPOFF) |
+ \\
+===== Test Setup =====
+{{:loconet:bdl168-rx4-setup-01.jpg?400}}\\
+ \\
+===== Links =====
+  * [[http://www.digitrax.com/menu_transponding.php|Digitrax]]
+  * [[http://www.dccwiki.com/Transponding|DCC Wiki]]
+  * [[http://en.wikipedia.org/wiki/Transponder|Wikipedia]]