no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== Philips HUE Accessory ======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[:english|Content]] -> **[[:english#command_stations|Command Stations]]** -> **Philips**
+   * [[:philips:hue-en|HUE Setup]] | [[:philips:hue-conf-en|HUE Configuration]] | **[[:philips:hue-sensors-en|HUE Accessory]]**
+{{https://developers.meethue.com/wp-content/themes/hue_developer_theme/img/site_logo.png}}
+ \\
+=====Accessory Types=====
+The following accessory types are supported:
+^ Type ^ Units ^ Remark ^
+| ZLLSwitch  | number [1,2,3,4] | Button number last pressed. |
+| ZLLPresence | boolean [0,1] | Movement detection. |
+| ZLLTemperature | hundreds of °C | Room temperature. |
+| ZLLLightlevel | log10 lux | Light level. |
+| Daylight | boolean [0,1] | True in case daylight is detected. |
+ \\
+=====Sensor Setup=====
+HUE sensors are numbered from 1 to 12, which are used as address in Rocrail.\\
+The sensor type must be set to register.\\
+**See also:**
+  * __**[[:philips:hue-en#sensors|Sensor Polling]]**__ must be activated.
+  * __**[[:philips:hue-conf-en#sensors|Sensor overview]]**__
+====Example====
+{{:philips:hue-reg-sensor2.png}}\\
+At which point the sensor will turn on/off, depends on the used threshold value on the interface tab.\\
+{{:philips:sensor-lux-int-en.png}}\\