no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== RocNetNode Turntable Multiport ======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]][[:rocnet:rocnetnode-en|{{ :rocnet:rocnet-hw.png}}]]
+[[:english|Content]] -> [[:english#command_stations|Command Stations]] ->  **[[rocnet:rocnet-prot-en|RocNet]]**
+  * [[rocnet:rocnet-prot-en|RocNet Protocol]] | **[[:rocnet:rocnetnode-en|RocNetNode]]**
+    * [[:rocnet:rocnetnode-hwsetup-en|RocNetNode Setup]] | [[:rocnet:rocnetnode-setup-en|RocNetNode Configuration]] | [[:rocnet:rocnetnode-img-en|Installer package]]
+    * [[:gca1-pi01-en|GCA-Pi01]] | [[:gca_pi02-en|GCA-Pi02]] | [[:gca-pi03-en|GCA-PI03]] | [[:gca-pi04-en|GCA-PI04]] | [[:gca-pi05-en|GCA-Pi05]] | [[:gca-pi06-en|GCA-Pi06]] | [[:gca107-en|GCA107 Relay board]]
+ \\
+=====Description=====
+{{  :mgv:hardware:GCA145_pict_01.jpg?300}}
+This example is based on the __**[[:gca145-en|GCA145]]**__ TT/FY controller with 6 bit track addressing and position bit.\\
+ \\
+=====Revision=====
+Use revision 6837+ for Turntables with Multiport interfaces in combination with RocNet.\\
+In previous revisions the Bus variable, which addresses the RocNetNode, was not part of the commands.\\
+ \\
+=====Interface=====
+Set IID and Bus according the RocNetNode to be used.\\
+{{:rocnet:tt-int.png}}\\
+ \\
+=====Multiport=====
+Select **Single Gate** for all multiport commands.\\
+{{:rocnet:tt-rn-single.png}}\\