analyzer-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| analyzer-en [2019/03/09 16:09] – old revision restored (2019/03/09 13:55) rainerk | analyzer-en [2019/03/09 22:17] – rainerk | ||
|---|---|---|---|
| Line 104: | Line 104: | ||
| |< >| | |< >| | ||
| ^ Important change from Rev. 15.164+ | ^ Important change from Rev. 15.164+ | ||
| - | | :!: It must always be clearly formed with **0...65535** numbered connector pairs.\\ The previously possible use of the numbers **0...9** for multiple connector pairs leads to the termination of the Analyzer run. \\ The orthogonal positioning and mutually facing cut surfaces of both symbols are no longer considered.\\ **So that the track plan for the analyzer is " | + | | :!: It must always be clearly formed with **0...65535**((=16bit value)) |
| ====Why connectors ?==== | ====Why connectors ?==== | ||
| Connectors can be used to connect distant elements: The analyser is seeking for a counterpart (second connector) in the same direction and ignores gaps and elements between these two.\\ | Connectors can be used to connect distant elements: The analyser is seeking for a counterpart (second connector) in the same direction and ignores gaps and elements between these two.\\ | ||