User Tools

Site Tools


dtc-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
dtc-en [2019/04/12 10:19]
rjversluis
— (current)
Line 1: Line 1:
-====== Dinasys Turntable Controller ====== 
-[[:​english#​command_stations|{{ ​ :​interface.png}}]][[:​english|{{ ​ :​rocrail-logo-35.png}}]] 
-[[:​english|Content]] -> [[:​english#​command_stations|Command Stations]] ->  **[[:​dtc-en|DTC]]** ​ 
- \\ 
- \\ 
-{{:​dinamo:​dtc.jpg}}\\ 
- \\ 
-===== Introduction ===== 
-This CS is to control __one__ turntable with the **D**inasys **T**urntable **C**ontroller.\\ 
-The Rocrail definition must be set to protocol **Multiport** and **Interface-ID** pointing to this controller.\\ 
- \\ 
  
-===== Setup ===== 
-All parameters are ignored except for **IID**, **Port** and **Version**. 
- 
-==== Port ==== 
-The serial device name connected to the DTC.\\ 
- 
-==== Options ==== 
-^ Version ^ Turntable Type ^ 
-| 0 | Default |  
-| 1 | DTC 48 tracks |  
-| 2 | DTC 24 tracks |  
-| 3 | DTZ 24 tracks 15° |  
- 
- \\ 
-=====Position sensor===== 
-If the end position has been reached it will be reported by sensor address **10001**.\\ 
-See: __**[[:​turntable-int-en#​position_sensors|Position sensor]]**__\\ ​ 
- 
- \\ 
- 
-=====Protocol===== 
-{{:​dinamo:​dtc-communicatie-1.2.pdf}} (NL) 
dtc-en.1555057147.txt.gz · Last modified: 2019/04/12 10:19 by rjversluis