gca145-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
gca145-en [2019/02/28 15:01] – [The firmware] phg | gca145-en [2019/05/08 12:00] – [Connections to GCA50 / CAN-GC2 / GCA_PI02] phg | ||
---|---|---|---|
Line 264: | Line 264: | ||
First the 6 bits are set according position.\\ | First the 6 bits are set according position.\\ | ||
To activate the GCA145, write enable should go high.\\ | To activate the GCA145, write enable should go high.\\ | ||
- | + | \\ | |
- | + | ^ Connections of rails on bridge can be done with following list. ^^ | |
- | + | | GCA(MGV)145 | |
+ | | J8(1) | left rail section 1 | | ||
+ | | J8(2) | left rail section 2 | | ||
+ | | J8(3) | left rail section 3 | | ||
+ | | J8(4) | left rail section 4 | | ||
+ | | J8(5) | right rail | | ||
+ | ^ addional connections | ||
+ | | J8(6) | 0V for signal | ||
+ | | J8(7) | 5V for signal | ||
+ | | J8(8) | not used | | ||
+ | | J8(9) | reverse side sign | | ||
+ | | J8(10) | ||
+ | **For signs only leds are applicable.**\\ | ||
gca145-en.txt · Last modified: 2023/06/20 14:56 by rainerk