User Tools

Site Tools


gca187-en

Differences

This shows you the differences between two versions of the page.


gca187-en [2020/07/10 22:17] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +====== GCA187 Signal Aspect Processor ======
 +[[english|{{  rocrail-logo-35.png}}]]
 +[[:english|Content]] -> [[:hardware-en|Hardware]] -> [[:hardware-en#interfaces|GCA]]
 +
 + \\
 +
 +^^^^By Peter Giling ^^^^
 +
 +{{:gca:gca187.png?400}}\\
 + \\
 +=====Introduction=====
 +The GCA187 can handle 8 aspects with 3 outputs.\\
 +
 +
 + \\
 +=====Aspect table=====
 +^ a0 ^ a1 ^ a2 ^ Aspect ^ Nr ^
 +| 0 | 0 | 0 | red | 0 |
 +| 1 | 0 | 0 | yellow | 1 |
 +| 0 | 1 | 0 | green | 2 |
 +| 1 | 1 | 0 | red flashing | 3 |
 +| 0 | 0 | 1 | green flashing | 4 |
 +| 1 | 0 | 1 | yellow flashing | 5 |
 +| 0 | 1 | 1 | red and green flashing | 6 |
 +| 1 | 1 | 1 | blank | 7 |
 +The aspect depends on the firmware flavour.\\
 +
 + \\
 +
 +=====Signal setup=====
 +The GCA187 must be setup as __**[[:signal-int-en#binary|Binary]]**__ control type.\\
 +
 +The screen shots show a setup with the __**[[:gca_pi02-en|GCA-Pi02]]**__:\\
 +[[:signal-int-en|{{:gca:signal-gca187-in-en.png}}]][[:signal-props-en|{{:gca:signal-gca187-details-en.png}}]]\\
 +
 +====Signal Addressing====
 +^ Connection ^ Address field ^
 +|  a0  | RED |
 +|  a1  | GREEN |
 +|  a2  | YELLOW |
 +
 +====Connector====
 +^ Pin ^ Function ^ GCA-Pi02 / CAN-GC2 / GCA50 ^
 +| 1 | +5V (VCC) |  1  |
 +| 2 |  a0  |  3..10  |
 +| 3 |  a1  |  3..10  |
 +| 4 |  a2  |  3..10  |
 +| 5 |  Ground (VSS) |  2  |
 +
 +
 + \\
 +
 +=====Files=====
 +  * https://gitlab.com/rocrail/GCA/tree/master/gca187
 +