no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+======Intellibox in LocoNet mode======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[english|Content]] -> [[english#command_stations|Command Stations]] ->   [[loconet-en| Digitrax LocoNet]]
+  *  **Command Stations** | [[loconet-interfaces-en|Interfaces]] | [[loconet-dev-en|Devices]] | [[locont-wi-en|Wiring]]
+    * [[loconet-setup-en|Setup]] | [[dcs100-en|DCS100/200 DB150]] | [[dsc50-en|DCS50 Zephyr]] | **IntelliBox** | [[ln-rocrail-cs-en|Slot Server]]
+// \\ // \\
+=====Overview=====
+  * LocoNet devices are not reported using the p50/p50x protocol.
+  * Using the LocoNet protocol all devices on the LocoNet bus are accessible.
+  * Support is excluded because the IB does behave not conform the LocoNet specs.
+ \\
+| Manufacturer | Uhlenbrock / Modeltreno |
+| Product info | {{http://wikihost.org/wikis/rocrail/images/link.png}} [[http://www.uhlenbrock.de/|http://www.uhlenbrock.de]] |
+| Description | The intellibox is a full featured command station. It has a build in RS232 interface that can be operated in a "LocoNet" mode. Than it behaves similar to a LocoBuffer. |
+ \\
+=====Configuration=====
+  - Upgrade the software inside the Intellibox to at least version 1.500: {{http://wikihost.org/wikis/rocrail/images/link.png}} [[http://www.uhlenbrock.de/|http://www.uhlenbrock.de]]
+  - Put the interface into mode "LocoNet":
+    * Basic settings -> interface -> syntax -> LocoNet
+  - Set baud rate to 19200 Baud:
+    * Basic settings -> interface -> bit per second -> 19200 bit/s
+  - Set the UART of the interface to 1 stop bits: (default 2)
+    * Basic settings -> special option -> SO 5 -> 1
+  - Disable SO 6: (default 254)
+    * Basic settings -> special option -> SO 6 -> 0
+Additonal Info: {{:ib:ib-so.pdf}}