no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+=====IntelliBox Basic, II and USB-LocoNet Interface=====
+[[:france#les_interfaces|{{  :interface.png}}]][[:france|{{  :rocrail-logo-35.png}}]]
+[[france|Table des matières]] -> [[france#les_interfaces|Les interfaces]] -> **Uhlenbrock**
+  * [[intellibox-fr|IntelliBox]] | **IntelliBox Basic, II and USB-LocoNet Interface**
+// \\ // \\
+===== Aperçu du produit =====
+L'IntelliBox Basic, II et l'Interface USB-LocoNet  supportent le protocole LocoNet via la connection USB.\\
+^ II ^ USB-LocoNet Interface ^ Basic ^
+|{{http://www.uhlenbrock.de/newitems/I96EF5D1-003.apd/ib_ii_web.jpg?200}}|{{:loconet:63120.jpg?200}}|{{http://www.uhlenbrock.de/I96EF2CB-004.apd/65060web.jpg?200}}| \\
+===== Configuration =====
+==== Interface ====
+:!: The LocoNet interface must be configured to **Direct mode** and **19200** baud:\\
+^ LNCV 2 = 1 | LocoNet Direct mode |
+^ LNCV 4 = 1 | 19200 Baudrate |
+Communication errors will occur if the interface is set up differently! \\
+ \\
+=== Debian 5 ===
+Debian 5 reconnait l'Interface USB LocoNet  et lui fait le mapping vers le lien /dev/ttyUSBx :\\
+<code>
+usb 1-1: New USB device found, idVendor=10c4, idProduct=ea60
+usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
+usb 1-1: Product: CP2102 USB to UART Bridge Controller
+usb 1-1: Manufacturer: Silicon Labs
+usb 1-1: SerialNumber: 0001
+usbserial: USB Serial support registered for cp2101
+cp2101 1-1:1.0: cp2101 converter detected
+usb 1-1: reset full speed USB device using uhci_hcd and address 2
+usb 1-1: cp2101 converter now attached to ttyUSB1
+usbcore: registered new interface driver cp2101
+cp2101: Silicon Labs CP2101/CP2102 RS232 serial adaptor driver v0.07
+</code>
+=== rocrail.ini ===
+La vitesse baud est réglée en usine à **115200** et **ne supporte pas le "hardware handshaking"**.\\
+Une configuration fonctionelle dans le fichier rocrail.ini ressemble à ceci:\\
+<code xml>
+  <digint iid="ln-1" lib="loconet" device="/dev/ttyUSB1" bps="115200" flow="none" sublib="serial"/>
+</code>