Differences

This shows you the differences between two versions of the page.

--- mbus:mbus-en [2020/02/24 15:11] – rjversluis
+++ mbus:mbus-en [2020/04/18 16:21] – [Tips] phg
@@ Line 10: / Line 10: @@
 The Command Station, Märklin TrackBox(GleisBox), is economically priced and supports the digital **DCC/MfX/MM2** protocols. A Mobile Station can be used as throttle and programmer.\\
-====Overview====
-{{mbus:mbus-socketcan.jpeg?400}}\\
 ====Devices====
 {{ :mbus:ms2.png}}
@@ Line 126: / Line 124: @@
 All addressing schemes are supported. (FADA/PADA/MADA)\\
 The bus value **must** be set to zero.\\
- \\
-=====GC2a Signal support=====
-This is for simple signals up to 4 LED and max. 5 aspects.\\
-Only the RED address will be used as offset for all LEDs.\\
-|< >|
-^ Parameter ^ Description ^
-| Control | Aspect numbers |
-| Port type | LED |
-| Bus | CAN-ID of the GC2a |
-| Addressing | FLAT from 1 to 16 - number of aspects |
-====Aspect Values====
-See: __**[[:signal-props-en#value|Aspect Values]]**__ \\
-The number of controlled LEDs will be calculated from the aspect values.\\
-===Example===
-===Aspect value examples===
-|< >|
-^ Value (dec) ^ LEDs ^
-| 0x01 (1) | LED 1 on |
-| 0x02 (2) | LED 2 on |
-| 0x04 (4) | LED 3 on |
-| 0x08 (8) | LED 4 on |
-| 0x11 (17) | LED 1 blinking |
-| 0x55 (85) | LED 1 and 3 blinking |
-| 0x03 (3) | LED 2 and LED 1 on |
-| 0x13 (19) | LED 2 on and LED 1 blinking |
  \\
 =====Tips=====
-  * Note: In order to show changes of loco functions in Rocview option **[[:rocrailini-automode-en#allow_zero_throttle_id|Allow Zero Throttle ID]]** has to be activated.
+  * Note: In order to show changes of loco functions in Rocview, option **[[:rocrailini-automode-en#allow_zero_throttle_id|Allow Zero Throttle ID]]** has to be activated.