philips:hue-sensors-en
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | philips:hue-sensors-en [2019/07/25 08:26] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Philips HUE Accessory ====== | ||
+ | [[: | ||
+ | [[: | ||
+ | * [[: | ||
+ | {{https:// | ||
+ | \\ | ||
+ | |||
+ | =====Accessory Types===== | ||
+ | The following accessory types are supported: | ||
+ | ^ Type ^ Units ^ Remark ^ | ||
+ | | ZLLSwitch | ||
+ | | ZLLPresence | boolean [0,1] | Movement detection. | | ||
+ | | ZLLTemperature | hundreds of °C | Room temperature. | | ||
+ | | ZLLLightlevel | log10 lux | Light level. | | ||
+ | | Daylight | boolean [0,1] | True in case daylight is detected. | | ||
+ | |||
+ | \\ | ||
+ | =====Sensor Setup===== | ||
+ | HUE sensors are numbered from 1 to 12, which are used as address in Rocrail.\\ | ||
+ | The sensor type must be set to register.\\ | ||
+ | **See also: | ||
+ | * __**[[: | ||
+ | * __**[[: | ||
+ | ====Example==== | ||
+ | {{: | ||
+ | At which point the sensor will turn on/off, depends on the used threshold value on the interface tab.\\ | ||
+ | {{: |
philips/hue-sensors-en.txt · Last modified: 2019/07/25 08:26 by 127.0.0.1