Differences

This shows you the differences between two versions of the page.

--- rascii-en [2019/09/17 17:05] – [Commands] rjversluis
+++ rascii-en [2022/12/11 00:48] (current) – obsolete trouble shooting section removed rainerk
@@ Line 3: / Line 3: @@
 [[:english|Content]] -> [[:english#command_stations|Command Stations]] ->  **[[rascii-en|RASCII]]**
  \\
-{{:arduino:uno-decspec-en.png}}{{:arduino:rascii-monitor-en.png}}\\
+{{:arduino:uno-decspec-en.png?300}}{{:arduino:rascii-monitor-en.png?300}}\\
+ \\
+=====Setup=====
+{{:rascii:rascii-setup-en.jpg?400}}
+====Options====
+===Ping===
+A Ping command will be sent with this interval in ms.\\
+Disabled in case of zero.\\
+The Ping can be used as "Dead man's switch".\\
  \\
@@ Line 102: / Line 111: @@
 |  12 |  #  | Accessory | Address, Port, aspect((0=straight, 1=turnout)) | - |
 |  13 |  #  | Mobile speed | Address-High, Address-Low, direction/speed((dir=0x80, speed=0x7F)) | - |
-|  14 |  #  | Mobile function | Address-High, Address-Low, function, value | - |
+|  14 |  #  | Mobile function | Address-High, Address-Low, function, value, lights, fx | Lights and FX(32bit) are for information only and optional. |
-|  15 |  #  | Mobile CV get | Address-High, Address-Low, CV-High, CV-Low | A CV number and value response. |
+|  37 |  #  | PT ON | none | A remark. |
-|  16 |  #  | Mobile CV set | Address-High, Address-Low, CV-High, CV-Low, value | - |
+|  38 |  #  | PT OFF | none | A remark. |
+|  39 |  #  | Accessory CV get | Address-High, Address-Low, CV-High, CV-Low | A CV number and value response. |
+|  40 |  #  | Accessory CV set | Address-High, Address-Low, CV-High, CV-Low, value | A remark. |
  \\
@@ Line 127: / Line 138: @@
  \\
-=====Trouble shooting=====
-====Windows crash nach Rocrail start====
-Some Windows configurations will crash at Rocrail server startup if the Arduino is connected by USB and the following option is not set:\\
-  * __**[[:rocrailini-controller-en#no_device_check_at_startup|No device check at startup]]**__