User Tools

Site Tools


rocnet:tt-setup-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

rocnet:tt-setup-en [2018/11/12 08:56] (current)
Line 1: Line 1:
 +====== RocNetNode Turntable Multiport ======
 +[[:​english#​command_stations|{{ ​ :​interface.png}}]][[:​english|{{ ​ :​rocrail-logo-35.png}}]][[:​rocnet:​rocnetnode-en|{{ :​rocnet:​rocnet-hw.png}}]]
 +[[:​english|Content]] -> [[:​english#​command_stations|Command Stations]] ->  **[[rocnet:​rocnet-prot-en|RocNet]]** ​
 +  * [[rocnet:​rocnet-prot-en|RocNet Protocol]] | **[[:​rocnet:​rocnetnode-en|RocNetNode]]**
 +    * [[:​rocnet:​rocnetnode-hwsetup-en|RocNetNode Setup]] | [[:​rocnet:​rocnetnode-setup-en|RocNetNode Configuration]] | [[:​rocnet:​rocnetnode-img-en|Installer package]]
 +    * [[:​gca1-pi01-en|GCA-Pi01]] | [[:​gca_pi02-en|GCA-Pi02]] | [[:​gca-pi03-en|GCA-PI03]] | [[:​gca-pi04-en|GCA-PI04]] | [[:​gca-pi05-en|GCA-Pi05]] | [[:​gca-pi06-en|GCA-Pi06]] | [[:​gca107-en|GCA107 Relay board]]
  
 +
 + \\
 +=====Description=====
 +{{  :​mgv:​hardware:​GCA145_pict_01.jpg?​300}}
 +This example is based on the __**[[:​gca145-en|GCA145]]**__ TT/FY controller with 6 bit track addressing and position bit.\\
 +
 + \\
 +=====Revision=====
 +Use revision 6837+ for Turntables with Multiport interfaces in combination with RocNet.\\
 +In previous revisions the Bus variable, which addresses the RocNetNode, was not part of the commands.\\
 +
 + \\
 +
 +=====Interface=====
 +Set IID and Bus according the RocNetNode to be used.\\
 +{{:​rocnet:​tt-int.png}}\\
 +
 + \\
 +=====Multiport=====
 +Select **Single Gate** for all multiport commands.\\
 +{{:​rocnet:​tt-rn-single.png}}\\
rocnet/tt-setup-en.txt ยท Last modified: 2018/11/12 08:56 (external edit)