roco:roco-wmz21-en
Differences
This shows you the differences between two versions of the page.
Previous revision | |||
— | roco:roco-wmz21-en [2025/05/16 15:06] (current) – [Rocrail] rjversluis | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Roco WLANmaus ====== | ||
+ | [[: | ||
+ | [[: | ||
+ | [[: | ||
+ | * [[: | ||
+ | | [[: | ||
+ | |||
+ | |{{: | ||
+ | | The WLANmaus; One for all. | System overview with Router, Rocrail Server and Command Station. | ||
+ | |||
+ | =====Introduction===== | ||
+ | The **wmz21** library emulates a Z21 Command Station and redirect the WLANmaus commands to any another Command Station, or directly to the matching Loco, Switch or other objects.\\ | ||
+ | Because every WLANmaus has its own IP-Address, this library can support multiple WLANmaus devices.\\ | ||
+ | |||
+ | Remarks: | ||
+ | * The **wmz21** library must be the last one in the controller list. | ||
+ | * The Z21 App maybe work also, but is not supported. | ||
+ | * The **wmz21** library cannot be used in combination with the **z21** library; They both use the same port which is not possible on the same computer. | ||
+ | \\ | ||
+ | |||
+ | =====Setup===== | ||
+ | ====WLANmaus==== | ||
+ | - See the manual to get WIFI access to the local network. (The display shows upper case characters only at typing the password, even when the shift function is off...) | ||
+ | - Change the Z21-IP-Address to the __**[[: | ||
+ | |||
+ | ====Rocrail==== | ||
+ | __**[[: | ||
+ | {{: | ||
+ | ===Interface ID=== | ||
+ | Unique name for this controller.\\ | ||
+ | ===Target=== | ||
+ | Add the library **wmz21** to the end of the Controller list, or set the **Target** accordantly to the wanted **Interface ID**.\\ | ||
+ | ===A2ID Prefix=== | ||
+ | Optional prefix in case of addressing type A2ID.\\ | ||
+ | ===Addressing=== | ||
+ | The __**[[: | ||
+ | ^ Scheme ^ Remark ^ | ||
+ | | FADA | Default flat addressing. | | ||
+ | | MADA | | | ||
+ | | PADA | | | ||
+ | | FADAM | The WLANmaus switch address divided by 100 is the bus, and the switch address modulo 100. | | ||
+ | | A2ID | The WLANmaus switch address will be used as Rocrail switch object ID, range: " | ||
+ | This is for converting the switch flat address send by the WLANmaus to a scheme which the target library supports.\\ | ||
+ | The A2ID scheme could be off use for systems using the bus number extensively like __**[[: | ||
+ | |||
+ | ===By Number=== | ||
+ | __**[[: | ||
+ | This is the easiest way for addressing Rocrail objects and is Command Station independent.\\ | ||
+ | Only the first one found of an object list will get the command. __Use Routes with numbers if multiple objects should be set with one click.__\\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Throttle ID===== | ||
+ | Every connected WLANmaus has its own IP address which is used as throttle ID in Rocrail. (For example: " | ||
+ | This can be used in combination with __**[[: | ||
+ | The WLANmaus request continuously information about the selected loco. If this loco is already controlled by another throttle, the loco image in the WLANmaus display will flash. (See manual section 2.3.)\\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Supported Commands===== | ||
+ | * Loco speed and direction | ||
+ | * Loco functions 0...28 | ||
+ | * Short IDs | ||
+ | * Switch, also by number (straight/ | ||
+ | * Route by number (set) | ||
+ | * Signal by number (flip) | ||
+ | * Output by number (flip) | ||
+ | * Turntable by number (next/ | ||
+ | * FiddleYard by number (next/ | ||
+ | * Power ON/OFF | ||
+ | * POM write \\ Change the WLANmaus programming mode: MENU -> PROGRAM -> MODE ->POM | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Transmit the Short IDs==== | ||
+ | First of all the __**[[: | ||
+ | |||
+ | To transmit all the **[[: | ||
+ | * MENU -> LOCO -> RECEIVE | ||
+ | Then select menu item “Control -> Transmit Short IDs” to send all Short IDs to all WLANmaus' | ||
+ | \\ | ||
+ | =====Virtual Machine===== | ||
+ | If the Rocrail server runs in a virtual machine, like VirtualBox, make sure the Network Adapter is bridged to be able to receive the WLANmaus packets.\\ | ||
+ | {{: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Links===== | ||
+ | * [[https:// | ||
+ | * [[https:// |