signal-int-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
signal-int-en [2020/04/03 10:52] – [Patterns] rjversluis | signal-int-en [2021/10/22 16:15] – [Aspect numbers] rjversluis | ||
---|---|---|---|
Line 39: | Line 39: | ||
* LEDii | * LEDii | ||
* WIO (WIP) | * WIO (WIP) | ||
- | \\ | + | |
+ | ====Parameter==== | ||
+ | Special settings for some Command Stations: | ||
+ | * **[[: | ||
+ | \\ | ||
===== Control ===== | ===== Control ===== | ||
Line 46: | Line 50: | ||
==== Patterns ==== | ==== Patterns ==== | ||
- | Signal decoders are most likely controlled with patterns on two ports. The patterns are set up on the **__[[signal-props-en# | + | Signal decoders are most likely controlled with patterns on two or three ports. The patterns are set up on the **__[[signal-props-en# |
See __**[[: | See __**[[: | ||
- | **Note:** Patterns can only be used with MADA addressing.\\ | + | **Note:** Patterns can only be used with PADA/MADA addressing, and max. 5 aspects. (2.1.601+) __FADA is not supported.__\\ |
Line 55: | Line 59: | ||
The following Command Stations are supported: | The following Command Stations are supported: | ||
* [[: | * [[: | ||
- | * [[: | + | * [[: |
* [[: | * [[: | ||
* [[: | * [[: | ||
Line 63: | Line 67: | ||
* [[: | * [[: | ||
* [[: | * [[: | ||
+ | * [[: | ||
| | ||
¹) [[http:// | ¹) [[http:// |
signal-int-en.txt · Last modified: 2023/09/12 08:11 by rjversluis