users:dagnall53:node_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
users:dagnall53:node_setup [2019/03/17 19:24] – ["FIXED" Functionality] dagnall53 | users:dagnall53:node_setup [2019/03/17 19:25] – dagnall53 | ||
---|---|---|---|
Line 68: | Line 68: | ||
I would recommend keeping D8 as an output as most boards have a relatively strong pull down resistor on this pin to assist with startup. This makes it harder to use as an input. | I would recommend keeping D8 as an output as most boards have a relatively strong pull down resistor on this pin to assist with startup. This makes it harder to use as an input. | ||
- | (As a very simplistic overview, NodePortType Determines if the port is Input or Output, Pi03_Setting_options determines if the output will be digital, PWM or a servo drive.) See also [[: | + | (As a very simplistic overview, NodePortType Determines if the port is Input or Output, Pi03_Setting_options determines if the output will be digital, PWM or a servo drive.) See also [[users: |