User Tools
users:dagnall53:node_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
users:dagnall53:node_setup [2019/03/17 19:24] dagnall53 ["FIXED" Functionality] |
users:dagnall53:node_setup [2019/03/17 19:25] (current) dagnall53 |
||
|---|---|---|---|
| Line 68: | Line 68: | ||
| I would recommend keeping D8 as an output as most boards have a relatively strong pull down resistor on this pin to assist with startup. This makes it harder to use as an input. | I would recommend keeping D8 as an output as most boards have a relatively strong pull down resistor on this pin to assist with startup. This makes it harder to use as an input. | ||
| - | (As a very simplistic overview, NodePortType Determines if the port is Input or Output, Pi03_Setting_options determines if the output will be digital, PWM or a servo drive.) See also [[:users:Dagnall53:ESP32Differences|ESP32 Setup]] | + | (As a very simplistic overview, NodePortType Determines if the port is Input or Output, Pi03_Setting_options determines if the output will be digital, PWM or a servo drive.) See also [[users:dagnall53:setting_up_wirocs_using_rocview|this guide]] for how to use RocView to set up a WiRocS node and [[:users:Dagnall53:ESP32Differences|ESP32 Setup]] |
users/dagnall53/node_setup.txt ยท Last modified: 2019/03/17 19:25 by dagnall53
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
