User Tools

Site Tools


users:dagnall53:setting_up_wirocs_using_rocview

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
users:dagnall53:setting_up_wirocs_using_rocview [2019/03/17 19:31]
dagnall53
users:dagnall53:setting_up_wirocs_using_rocview [2019/03/17 19:34] (current)
dagnall53
Line 20: Line 20:
 If any of the Pi02 ports were set with “Blink”,​ they will blink/flash with a delay set by the Delay setting. ​ If any of the Pi02 ports were set with “Blink”,​ they will blink/flash with a delay set by the Delay setting. ​
 “Invert” would  invert the port  phase. “Invert” would  invert the port  phase.
-Note Rocrail does not know that some ports are “FIXED”,​ but if you try to modify them they will revert to their “FIXED” ​settngs.+Note Rocrail does not know that some ports are “FIXED”,​ but if you try to modify them they will revert to their “FIXED” ​settings.
  
 Pressing “Pi03 Channel Setup” shows further information about our 8 io pins: Pressing “Pi03 Channel Setup” shows further information about our 8 io pins:
Line 31: Line 31:
  
  
 +====== Loco ======
  
 Because this example is a “loco” at address 7 we can look at the throttle: ​ Because this example is a “loco” at address 7 we can look at the throttle: ​
Line 40: Line 41:
 To make this work, you need to select “POM” and the loco to be programmed in the top left box, and Rocrail will interrogate the set loco address and get the main CV settings:  ​ To make this work, you need to select “POM” and the loco to be programmed in the top left box, and Rocrail will interrogate the set loco address and get the main CV settings:  ​
  
 +====== ESP32 ====== 
 +Programming the ESP 32 is almost identical to the ESP8266, except that there are 16 Io potentially available. Not all are fully selectable for all functionality,​ and there are some limitations on how these ports can be used, but the code should limit any attempts to set the nodes to unavailable functionalites. See [[users:​dagnall53:​esp32differences|ESP32]]
  
  
users/dagnall53/setting_up_wirocs_using_rocview.txt · Last modified: 2019/03/17 19:34 by dagnall53