6050-en
Differences
This shows you the differences between two versions of the page.
| — | 6050-en [2021/05/07 21:10] (current) – created - external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ======Marklin 6050/ | ||
| + | [[: | ||
| + | |||
| + | [[english|Content]] -> [[english# | ||
| + | |||
| + | |||
| + | // \\ // \\ | ||
| + | | Deprecated and no longer supported! | ||
| + | |||
| + | Because of the lack of a direction bit in this ancient protocol some features will probably not work in auto mode.\\ | ||
| + | |||
| + | =====Cable configuration===== | ||
| + | Interface 6050/6051 to RS232 | ||
| + | | **DIN-6** | **D-SUB-9** | Label | | ||
| + | | 1 | 3 | Rx | | ||
| + | | 4 | 2 | Tx | | ||
| + | | 5 | 8 | CTS | | ||
| + | | 3 | 5 | Ground | | ||
| + | |||
| + | **Bridge** on D-SUB-9 side pin: **4 - 6 - 1** | ||
| + | |||
| + | |||
| + | =====Settings===== | ||
| + | General Command Station setup dialog:\\ | ||
| + | {{: | ||
| + | |||
| + | ====Line settings==== | ||
| + | ===Baudrate=== | ||
| + | 2400\\ | ||
| + | ===Hardware Flow=== | ||
| + | CTS\\ | ||
| + | |||
| + | ====Sensors==== | ||
| + | ===Number=== | ||
| + | Number of s88 units. | ||
| + | |||
| + | ====Version==== | ||
| + | |< >| | ||
| + | ^ Version ^ Command sleep ^ comment ^ | ||
| + | | 0 | 0ms | | | ||
| + | | 1 | 10ms | | | ||
| + | | 2 | 50ms |otherwise cts timeout| | ||
| + | With version 2, the direction change will skip the preceding speed zero command.\\ | ||
| + | |||
| + | ====Switch time==== | ||
| + | Time in ms to wait after the last switch command before a switch off command is send to prevent coil damaged.\\ | ||
| + | Use 1000 (if old and slow magnetic objects) | ||
| + | |||
| + | \\ | ||
| + | =====Interface 6023===== | ||
| + | The 6023 interface must be switched to binary mode for using this protocol; Read section 6 on how to switch to binary mode.\\ | ||
| + | * {{: | ||
| + | |||
| + | \\ | ||