Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+[[:english|{{ :hardware.png}}]][[:english|{{ :rocrail-logo-35.png}}]]
+====== WIO Mobile ======
+[[:wio:overview-en|{{ :wio:wiologo.png}}]]
+**[[:wio:overview-en|WIO Overview]]**
+  * [[:arduino:wio-setup-en|WIO Setup]] | [[:arduino:wio-en|WIO Firmware]] | [[:arduino:amp-en|User Bitmaps]] | [[:wio:wio-ledscript-en|LEDScript]]
+    * [[:arduino:wioctrl-en|WIO Control]]
+    * **[[:arduino:wio-mobile-en|WIO Mobile]]**
+    * [[:arduino:wio-dcc-en|WIO DCC]]
+ \\
+=====PWM Settings=====
+The PWM multiplier can only be set by serial monitor. (*pwm=x)\\
+The default is 1, and generates a 20kHz PWM by 50 speed steps.\\
+====G-Scale====
+The test is being made with a Piko V20.
+  * 11.1V (2.2A LiPo battery)
+  * 10Hz (*pwm=1000)
+  * 100 speed steps
+  * Mass 10
+  * Step range 5-100
+With an 10Hz PWM the motor has power enough and do not need any speed control and or kick start.\\
+The mass value will be automatically increased in the lower duty cycle range.\\
+ \\
+=====Rocrail Settings=====
+====Locomotive Interface====
+^ Field ^ Value ^
+| Interface ID | WIO |
+| Bus | WIO-Mobile ID |
+| Address | Not used |
+| Decoder steps | 100...128 |
+| Mass | 25 |
+| Step range | 4...50 |