Differences

This shows you the differences between two versions of the page.

--- gca173-en [2025/06/09 21:36] – [Magnets] phg
+++ gca173-en [2025/06/09 21:44] (current) – [One other interesting option with these sensors:] phg
@@ Line 8: / Line 8: @@
 ^^^^By Peter Giling ^^^^
-|  This Unit is **NOT** 3V3 compatible  |
+|  **This Unit is NOT 3V3 compatible, because Hall-sensors need minimal 5V.**  |
@@ Line 90: / Line 90: @@
 \\
-===== One other interesting option with these sensors: =====
+===== One neww interesting option with GCA173 =====
-Using Loc-combinations, where one is a s.c. 'dummy-loc', which is not taking any current from the track, this combination might stop too late, where current detection is used and the dummy is in front.\\
+With the introduction of
-The use of two magnets -one at each front- will solve this problem simple and easy.\\
  \\
@@ Line 159: / Line 158: @@
 ===== Connection to reed-switch =====
-Allthough GCA173 can work fine with reed-switch as wel, the option for wheel counter is NOT applicable.\\
+Allthough GCA173 can work fine with reed-switch as well, the option for wheel counter is NOT applicable.\\
 This due to the fact the the number of pulses, generated on the passing of a magnet is never the same, and unpredictable.\\
 {{:mgv:hardware:connection_reed-switch.pdf|connection to reed-switch}}\\