Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+======Drag and Drop======
+{{  rocrail-logo-32.png}}
+[[english|Content]] -> [[english#rocview|Rocview]]->[[english#general|General]]
+  *  [[rocgui-config-en|Configuration]] | [[loc-tab-en|Locomotives Tab]] | [[gui-accel-en|Accelerators]] | **Drag and Drop** | [[gui-cs-status-en|Command Station Status]] | [[gui-multi-en|Use multiple Gui's for viewing]] | [[gui-reports-en|Reports]]
+// \\ // \\
+{{:rocview:dd.png}}\\
+ \\
+^  :!: Block and Route permissions are disregarded by using D&D.  ^
+ \\
+===== From Loco tab to block  =====
+==== Left mouse button: ====
+The ID cell and the loco picture can be dragged to set a loco in a block. If the block was already occupied it will be freed-up first. \\
+> Note: __**With Linux and OSX you can also D&D a loco to a different level. Drop the Loco on the tab of the level and it opens up, then place the loco in the desired block.**__ \\
+ \\
+===== From block to block  =====
+==== Left mouse button + ctrl + alt: ====
+If pressing the control+alt keys before dragging will add a block to the trip.\\
+> **Note:** Multiple same block IDs are not supported in a block trip.
+==== Left mouse button: ====
+Set the destination, or end of block trip, for a train and issue the command "GO".\\
+==== Left mouse button + ctrl: ====
+If pressing the control key before dragging it will move a train from one block to the other.\\
+**Note:** //Does not work on macOS; Use Shift+Alt instead.//\\
+==== Left mouse button + shift + alt: ====
+If pressing the shift and alt key before dragging it will move a train from one block to the other.\\
+**Note:** //Available starting with version 2.1.3066+.//\\
+==== Left mouse button + shift ====
+A list of possible schedules will popup if the __**[[:finder:finder-en|Finder]]**__ is active.\\
+After selecting a schedule the train will get a GO command with the schedule.\\
+==== Left mouse button + alt: ====
+If pressing the alt key before dragging will set the pass through block to the train.\\
+The train will not go into the idle state after reaching this block.\\
+ \\
+===== Start a loco in a block =====
+Since the arrival of Drag&Drop the single left mouse click had to be sacrificed. A double click is needed to start a loco in a block.\\