no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== RocNet FAQ's ======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]][[:rocnet:rocnetnode-en|{{ :rocnet:rocnet-hw.png}}]]
+[[:rocnet:faq-en|{{ icons:uk.png}}]][[:rocnet:faq-de|{{ icons:de.png}}]]
+[[:english|Content]] -> [[:english#command_stations|Command Stations]] ->  **[[rocnet:rocnet-prot-en|RocNet]]**
+  * [[rocnet:rocnet-prot-en|RocNet Protocol]] | **[[:rocnet:rocnetnode-en|RocNetNode]]**
+    * [[:rocnet:rocnetnode-hwsetup-en|RocNetNode Setup]] | [[:rocnet:rocnetnode-setup-en|RocNetNode Configuration]] | [[:rocnet:rocnetnode-img-en|Installer package]] | [[:rocnet:article-en|MERG Journal]]
+  * [[:gca:gca-index-en#raspbery_pi_rocnet_boards|Raspberry Pi Boards]]
+    * [[:gca1-pi01-en|GCA-Pi01]] | [[:gca_pi02-en|GCA-Pi02]] | [[:gca-pi03-en|GCA-PI03]] | [[:gca-pi04-en|GCA-PI04]] | [[:gca-pi05-en|GCA-Pi05]] | [[:gca-pi06-en|GCA-Pi06]] | [[:GCA-PI07-en|GCA-PI07]] | [[:gca107-en|GCA107 Relay board]]
+  * [[:rocnet:rocnetnode-build-en|Build from source]] | [[:raspi:raspi-dev-en|RasPi as Rocrail server]]
+  * **[[:rocnet:faq-en|FAQ's]]**
+ \\
+=====Programming the GCA136 on RocNetNode=====
+When using GCA136 on RocNetNote following notes should be considered when programming:\\
+. "Single Gate" has to be ticked in the programming dialogue\\
+. Using the programming dialogue can result in unexpected servo movements\\
+Restarting this dialog will cure this problem.\\
+(Servos have to be only react on programming actions)\\
+. When upgrading from Loconet to RocNetNode:\\
+Former servo progamming is still valid, but if you enter the servo programming dialogue, the adjustments\\
+have to be made new. By changing protocol/address RocRail lose the adjustment Information.\\