Content → Command Stations → RocNet

• RocNet Protocol | RocNetNode
  • RocNetNode Setup | RocNetNode Configuration | Installer package | MERG Journal
• Raspberry Pi Boards
  • GCA-Pi01 | GCA-Pi02 | GCA-PI03 | GCA-PI04 | GCA-Pi05 | GCA-Pi06 | GCA-PI07 | GCA107 Relay board
• Build from source | RasPi as Rocrail server
• FAQ's

When using GCA136 on RocNetNote following notes should be considered when programming:

1. "Single Gate" has to be ticked in the programming dialogue

2. Using the programming dialogue can result in unexpected servo movements
Restarting this dialog will cure this problem.
(Servos have to be only react on programming actions)

3. When upgrading from Loconet to RocNetNode:
Former servo progamming is still valid, but if you enter the servo programming dialogue, the adjustments
have to be made new. By changing protocol/address RocRail lose the adjustment Information.