no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== RocNetNode Servo Switch Setup ======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]][[:rocnet:rocnetnode-en|{{ :rocnet:rocnet-hw.png}}]]
+[[:english|Content]] -> [[:english#command_stations|Command Stations]] ->  **[[rocnet:rocnet-prot-en|RocNet]]**
+  * [[rocnet:rocnet-prot-en|RocNet Protocol]] | **[[:rocnet:rocnetnode-en|RocNetNode]]**
+    * [[:rocnet:rocnetnode-hwsetup-en|RocNetNode Setup]] | [[:rocnet:rocnetnode-setup-en|RocNetNode Configuration]] | [[:rocnet:rocnetnode-img-en|Installer package]]
+    * [[:gca1-pi01-en|GCA-Pi01]] | [[:gca_pi02-en|GCA-Pi02]] | [[:gca-pi03-en|GCA-PI03]] | [[:gca-pi04-en|GCA-PI04]] | [[:gca-pi05-en|GCA-Pi05]] | [[:gca-pi06-en|GCA-Pi06]] | [[:gca107-en|GCA107 Relay board]]
+ \\
+ \\
+=====The example=====
+This example shows how to setup a switch controlled by a **[[:rocnet:rocnetnode-en|RocNetNode]]** servo including:
+  * Interface
+  * Field feedback (Wiring)
+  * Frog polarisation.
+ \\
+=====General=====
+{{:rocnet:sw-gen-en.png}}\\
+ \\
+=====Interface=====
+Set the bus to the RocNetNode-ID, the port type to **Servo** and the address to the channel on which the servo is connected.\\
+{{:rocnet:sw-int-en.png}}\\
+ \\
+=====Wiring=====
+The **[[:rocnet:rocnetnode-en|RocNetNode]]** wait with generating a 'field event' until the wanted pulse width, position, has been reached.\\
+| Only set **Use field events** for this servo controlled switch. | The __**[[:rocnet:rocnetnode-setup-en#report1|Channel Report]]**__ option must be activated for this functionality. |
+| {{:rocnet:sw-wiring-en.png}} | {{:rocnet:sw-channel-setup-en.png}} |\\
+ \\
+=====Frog=====
+Just set the two relay addresses for frog 1.\\
+These addresses are most likely located on a **[[:gca_pi02-en|GCA-Pi02]]** in combination with a **[[:gca107-en|GCA107]]**.\\
+{{:rocnet:sw-frog-en.png}}\\