no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== Registratore Comandi ======
+[[:italian#rocview|{{  :viewer.png}}]][[:italian|{{  :rocrail-logo-35.png}}]]
+[[:italian|Indice]] -> [[:italian#rocview|Rocview ]]
+  * **Registratore Comandi**
+ \\
+| //Menu -> Controllo -> Registratore Comandi// |
+ \\
+=====Introduzione=====
+Il registratore comandi può essere usato per registrare tutti i comandi inviati da Rocview al server.\\
+{{:rocview:cmdrecorder-en.png}}\\
+ \\
+===== Caratteristiche =====
+  * Registra tutti i comandi come testo
+  * Play back
+  * Esportazione e importazione
+  * Modificare, inserire e cancellare comandi
+  * Opzione orario; deve essere attivata prima dell'avvio della registrazione.
+====Nota====
+  * Non tutti i comandi sono supportati.
+ \\
+=====Registrare un itinerario=====
+With the following 10 steps a route can be created:
+  - Make sure Rocview is online. (Connected with the Rocrail server.)
+  - Reset all involved blocks from occupancy.
+  - Start recording.
+  - Click on the start block. -> Use Shift+Click for choosing the plus block side.
+  - Click on all needed switches, signals and sensors. \\ To get the wanted command correctly in the route use the context menu instead of a single click to select the right command.
+  - Click on the destination block. -> Use Shift+Click for choosing the plus block side.
+  - Optional click on the crossing blocks.
+  - Stop the recording.
+  - Optional modify some recorded lines.
+  - Push the **Route** button.
+The new route will be shown in the Route Dialog to be able to make some changes or set options if needed.\\
+After pushing the OK button the recorded route will be send to the Rocrail server will show up in the Route Table. With Cancel the recorded route will be rejected.\\
+ \\
+**Notes:**
+  * //Works with Standard and with Staging Blocks.//
+  * //Steps 5 and 6 may be mixed.//
+  * //The generated route ID is formatted as: **[from block ID+/-]-[to block ID+/-]**//
+  * //Pause lines will be ignored.//
+  * //If some switches and/or signals were left clicked the correct commands can be adjusted in the Route Dialog.//
+ \\
+=====Formato File=====
+<code>
+type,<id>,<cmd>
+</code>
+Sono permessi solo linefeed; no carriage return supplementari. (DOS/Windows)\\
+La "Pausa" non è un comando ma è usato per attendere un numero di secondi tra i vari playback.\\
+====Esempio====
+<code>
+fb,fb3a,true
+pause,2
+fb,fb3b,true
+pause,2
+sw,sw2,flip
+</code>