User Tools

Site Tools


bidib-compat-en
no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.


bidib-compat-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +====== OpenDecoder ======
 +[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 +[[:english|Content]] -> [[:english#command_stations|Command Stations]] ->  **[[:bidib-en|BiDiB]]** 
 +  * [[:bidib:bidib-config-en|Configuration]] | [[:bidib-examples-en|Setup examples]] | [[:bidib-usb-en|USB Mapping]] | **[[:bidib-compat-en|OpenDecoder]]**
 + \\
 + \\
 +=====OpenDecoder 1=====
 +[[http://opendcc.de/elektronik/opendecoder/opendecoder.html|{{ http://opendcc.de/elektronik/opendecoder/platine_bestueckt.jpg?200}}]]
 +====Mode 3====
 +  * [[http://opendcc.de/elektronik/opendecoder/opendecoder_sw_signal.html|3 or 4 aspects with distant signal and blank at HP0/Sh1]]
  
 +===Main signal=== 
 +  - Interface 
 +    * Protocol: **NMRA-DCC**
 +    * Address Main Signal: 1, 5, 9 or 13 and so on. (Flat addressing: 8 addresses per decoder)
 +    * Port: 0, Flat addressing 
 +    * Control: Linear 
 +    * Type: **Accessory** 
 +    * Option: As switch 
 +  - Details
 +    * Aspects: 3 or 4 
 +    * Signal Type: Lights 
 +    * Signification: Main
 +    * Aspect number: green=2, red=1, yellow=0, white=3 
 +
 + \\
 +==Important==
 +The aspect numbers will map the output/aspect of the decoder; Change according your needs.\\
 +  * In case the signal symbol shows "red" and the signal LED is showing "green", just swap 2 and 1. Keep the aspect numbers in the range of 0 - 3; Higher values will address the next decoder. 
 +
 +===Distant signal===
 +Use the same settings as for the main signal except for: 
 +  - Interface
 +    * Address: 3, 7, 11, or 15 and so on. 
 +  - Details
 +    * Aspects: 3 or 2 
 +    * Signification: Distant
bidib-compat-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1