block-statistics-en
Differences
This shows you the differences between two versions of the page.
— | block-statistics-en [2024/01/25 14:44] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Block Statistics ====== | ||
+ | [[: | ||
+ | [[: | ||
+ | * [[block-index-en|Index]] | [[: | ||
+ | |||
+ | // \\ // \\ | ||
+ | |||
+ | {{: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | =====Introduction===== | ||
+ | There are also statistics for sensors, but some Command Stations, like LocoNet, are note able to send both the sensor address and loco address in case of a QoS report. (Packet is too small...)\\ | ||
+ | In this case the QoS is redirected to the loco, and if the loco is logically in a block it will on its turn redirect this information.\\ | ||
+ | |||
+ | |||
+ | In combination with RailCom this Statistic Tab can be filled with signal quality reports. (0...100%)\\ | ||
+ | \\ | ||
+ | The individual cell background color will be white for zero values and pure red for values greater or equal then 50.\\ | ||
+ | The red saturation for all values less then 50 are interpolated.\\ | ||
+ | \\ | ||
+ | The values reported are the percentage of the lost packets; The higher the value, the worse the quality.\\ | ||
+ | * If the red color is horizontal, the rails connected to the specified sensor should be cleaned. | ||
+ | * If it is vertical, the wheels of the specified locomotive should be cleaned.\\ | ||
+ | \\ | ||
+ | Supported Command Stations: | ||
+ | * LocoNet (Z21 LocoNet) | ||
+ | \\ | ||
+ | |||
+ | =====Delete===== | ||
+ | Delete all statistic records of the selected block.\\ | ||
+ | |||
+ | |||
+ | |||
+ | =====Show all===== | ||
+ | Show all statistic records from all blocks in one grid.\\ | ||
+ | |||
+ | ===== Cleaning ===== | ||
+ | Timestamp of when the block was last used by a train type of "Track cleaning" | ||
+ | A route to a free block with the lowest time stamp value is reserved for locomotives / trains with the "Track cleaning" | ||
+ | \\ |