Differences

This shows you the differences between two versions of the page.

--- car-int-en [2018/11/12 08:56] – external edit 127.0.0.1
+++ car-int-en [2023/03/05 08:05] (current) – [Interface] rjversluis
@@ Line 6: / Line 6: @@
  \\
 ===== Interface =====
-{{:car-int-en.png}}{{:loco-car-ctrl-en.png}}\\
+{{:car-int-en.png?720}}{{:loco-car-ctrl-en.png}}\\
 A car decoder can be controlled with **[[:actions-en#types_commands_parameters|function actions]]**.\\
 If the address > 0 the car will be also listed in the **[[:loc-throttle-en|loco control dialog]]**.\\
@@ Line 21: / Line 21: @@
  \\
-====Interface ID====
+=====Interface ID=====
-Only set this to the IID you set in the rocrail.ini if your setup has more than one CS connected.\\
+If more than one command station is used, then the command station that is responsible for controlling the decoder is specified in this field. The "Interface identifier" field can remain empty if the object is connected to the first command station (first 'digint' in rocrail.ini) from the list of command stations.
  \\
@@ Line 43: / Line 43: @@
 ====Direction====
 Send direction and velocity commands from the operator/throttle to the function decoder.
-===Invert====
+This option is required if a control car's lights are to be changed together with the locomotive in a train.
+====Invert=====
 Invert the direction before sending it.
-===Placing====
+====Logical Direction====
 Checked is default, unchecked is swapped.
+====Speed====
+Check to activate the "Speed" translation table.
 ====Lights====
 Send a function command from the operator to the function decoder.\\
 Use the function number if the lights are not mapped to F0.\\
-===Speed command===
+This option is required if a control car's lights are to be changed together with the locomotive in a train.
+====Speed command====
 Send a speed command for function 0 instead of a function command.\\