cbus:flim-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
cbus:flim-en [2019/05/05 12:54] – [Query] tip added redtrain | cbus:flim-en [2020/07/06 14:38] (current) – phg | ||
---|---|---|---|
Line 15: | Line 15: | ||
=== FLiM === | === FLiM === | ||
**F**ull **L**ayout **i**nterface **M**odel.\\ | **F**ull **L**ayout **i**nterface **M**odel.\\ | ||
- | All settings of the modules made with programming commands over the CBUS. \\ | + | All settings of the modules made with programming commands over the CANBUS. \\ |
- | In Rocrail the CBUS programming dialog is implemented on multiple tabs for general and modules-specific properties. \\ | + | In Rocrail the CANBUS |
Line 44: | Line 44: | ||
====Number/ | ====Number/ | ||
The target node must be set manually in learn mode, after its powered on, by pushing short the button on the board before setting a new node number.\\ | The target node must be set manually in learn mode, after its powered on, by pushing short the button on the board before setting a new node number.\\ | ||
- | If there are nodes in the same CBUS in SLiM mode it is recommended to choose a node number higher than 255 to avoid conflicts. All CAN-GCA nodes are FLiM only.\\ | + | If there are nodes in the same CANBUS |
cbus/flim-en.txt · Last modified: 2020/07/06 14:38 by phg