User Tools
cc-schnitte-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
cc-schnitte-en [2019/06/03 08:40] rjversluis |
cc-schnitte-en [2019/06/03 08:41] (current) rjversluis |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| =====CC-Schnitte V2===== | =====CC-Schnitte V2===== | ||
| - | This version uses the Märklin CS2 protocol:\\ | + | This version uses the Märklin CS2 CAN protocol.\\ |
| - | * {{:cs2:cs2can-protokoll-2_0.pdf}} | + | |
| [[http://www.can-digital-bahn.com/modul.php?system=sys5|{{http://www.can-digital-bahn.com/pages/module/CC_Schnitte/images/CC_Schnitte_2_1_klein.jpg?200}}]]\\ | [[http://www.can-digital-bahn.com/modul.php?system=sys5|{{http://www.can-digital-bahn.com/pages/module/CC_Schnitte/images/CC_Schnitte_2_1_klein.jpg?200}}]]\\ | ||
| Line 13: | Line 12: | ||
| ====Setup==== | ====Setup==== | ||
| Set it up as a **[[:mbus:cs3-en|Märklin CS2/CS3]]** CS with type serial.\\ | Set it up as a **[[:mbus:cs3-en|Märklin CS2/CS3]]** CS with type serial.\\ | ||
| - | {{:cs2:mcs2-cc-en.png}}\\ | ||
| Read also: __**[[:mbus:mbus-en|MBUS & TrackBox]]**__\\ | Read also: __**[[:mbus:mbus-en|MBUS & TrackBox]]**__\\ | ||
| Line 31: | Line 29: | ||
| ===Version=== | ===Version=== | ||
| The version should be set to 2 to disable S88 polling continually.\\ | The version should be set to 2 to disable S88 polling continually.\\ | ||
| - | |||
| - | ===Sensor range=== | ||
| - | The sensor range to be queried at "Start of Day". | ||
| ====Command Pause==== | ====Command Pause==== | ||
cc-schnitte-en.txt · Last modified: 2019/06/03 08:41 by rjversluis
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
