g_ash03-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
g_ash03-en [2018/12/26 14:06] – [G_ASH03 DCC universal function decoder.] phg | g_ash03-en [2018/12/26 14:21] (current) – [Description] phg | ||
---|---|---|---|
Line 9: | Line 9: | ||
===== Description ===== | ===== Description ===== | ||
- | This is most certainly one out of many function | + | This is most certainly one out of many function |
Based on the use of an Arduino Nano board, it contains software avalable from Mardec.\\ | Based on the use of an Arduino Nano board, it contains software avalable from Mardec.\\ | ||
This unit can control up te 12 Servomotors, | This unit can control up te 12 Servomotors, | ||
Line 17: | Line 17: | ||
* GCA77 8 x 0,5 A output switch | * GCA77 8 x 0,5 A output switch | ||
* GCA107 8 x relay board. | * GCA107 8 x relay board. | ||
+ | Because this unit is directly connected to DCC, it is not possible to use it for input.\\ | ||
+ | GCA does not support S88 connections in any way.\\ | ||
+ | Configuration and adjustment of servo' | ||
+ | See descirption below.\\ | ||
+ | The G-ASH-03 has an isolated input for DCC, and needs a separate power source like a 12V 1Amp adapter.\\ | ||
+ | Two jumpers on board make it possible to use the DCC power from the rails for supply.\\ | ||
+ | It is not my favorite, because:\\ | ||
+ | a) you will need much more ' | ||
+ | b) any shut off in the DCC booster/ | ||
+ | |||
\\ | \\ | ||
\\ | \\ | ||
Line 23: | Line 33: | ||
| {{ : | | {{ : | ||
| {{ : | | {{ : | ||
+ | ===== Firmware and configuration program ===== | ||
+ | All you need can be found here:\\ | ||
+ | https:// |
g_ash03-en.1545829584.txt.gz · Last modified: 2018/12/26 14:06 by phg