g_ash03-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
g_ash03-en [2018/12/26 14:15] – [Description] phg | g_ash03-en [2018/12/26 14:21] (current) – [Description] phg | ||
---|---|---|---|
Line 20: | Line 20: | ||
GCA does not support S88 connections in any way.\\ | GCA does not support S88 connections in any way.\\ | ||
Configuration and adjustment of servo' | Configuration and adjustment of servo' | ||
- | See descirption below. | + | See descirption below.\\ |
- | The G-ASH-03 has an isolated input for DCC, and needs a separate power source like a 12V 1Amp adapter. | + | The G-ASH-03 has an isolated input for DCC, and needs a separate power source like a 12V 1Amp adapter.\\ |
Two jumpers on board make it possible to use the DCC power from the rails for supply.\\ | Two jumpers on board make it possible to use the DCC power from the rails for supply.\\ | ||
- | It is not my favorite, because: | + | It is not my favorite, because:\\ |
- | a) you will need much more ' | + | a) you will need much more ' |
- | b) any shut off in the DCC booster will also cause the funktion | + | b) any shut off in the DCC booster/command station |
\\ | \\ | ||
Line 33: | Line 33: | ||
| {{ : | | {{ : | ||
| {{ : | | {{ : | ||
+ | ===== Firmware and configuration program ===== | ||
+ | All you need can be found here:\\ | ||
+ | https:// |
g_ash03-en.1545830126.txt.gz · Last modified: 2018/12/26 14:15 by phg