gca_rfid-en
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
gca_rfid-en [2018/11/12 08:56] – external edit 127.0.0.1 | gca_rfid-en [2019/12/06 11:20] – [Pin connections] rjversluis | ||
---|---|---|---|
Line 29: | Line 29: | ||
^ Pin# ^ Function | ^ Pin# ^ Function | ||
| 1 | Ground | | 1 | Ground | ||
- | | 2 | + 5 Volt | | | | + | | 2 | + 5 Volt | + 3.3V in case of ID-12LA and WIO Mobile |
| 3 | Non Inverse output | | 3 | Non Inverse output | ||
| 3 | Inverse output (R2 + R6 installed) \\ R6 only if 3.3 V output is required | | 3 | Inverse output (R2 + R6 installed) \\ R6 only if 3.3 V output is required | ||
Line 46: | Line 46: | ||
| Pin 1 | Pin 1 | GND | | | | Pin 1 | Pin 1 | GND | | | ||
| Pin 2 | Pin 2 | +5V | | | | Pin 2 | Pin 2 | +5V | | | ||
- | | Pin 3 | Pin 3 | Signal | + | | Pin 3 | Pin 3 |
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | ^ Connection with WIO Mobile | ||
+ | ^ GCA_RFID J1 ^ WIO Mobile | ||
+ | | Pin 1 | GND | GND | | | ||
+ | | Pin 2 | +3.3V | +3.3V | | | ||
+ | | Pin 3 | RX | ||
\\ | \\ | ||
\\ | \\ |
gca_rfid-en.txt · Last modified: 2023/07/09 07:47 by rjversluis