User Tools

Site Tools


gui-dnd-en

Differences

This shows you the differences between two versions of the page.


gui-dnd-en [2024/07/07 17:16] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +======Drag and Drop======
 +{{  rocrail-logo-32.png}}
 +[[english|Content]] -> [[english#rocview|Rocview]]->[[english#general|General]] 
 +  *  [[rocgui-config-en|Configuration]] | [[loc-tab-en|Locomotives Tab]] | [[gui-accel-en|Accelerators]] | **Drag and Drop** | [[gui-cs-status-en|Command Station Status]] | [[gui-multi-en|Use multiple Gui's for viewing]] | [[gui-reports-en|Reports]]
 +// \\ // \\
 +{{:rocview:dd.png}}\\
 + \\
  
 +
 +^  :!: Block and Route permissions are disregarded by using D&D.  ^
 +
 + \\
 +
 +===== From Loco tab to block  =====
 +
 +==== Left mouse button: ====
 +
 +The ID cell and the loco picture can be dragged to set a loco in a block. If the block was already occupied it will be freed-up first. \\
 +> Note: __**With Linux and OSX you can also D&D a loco to a different level. Drop the Loco on the tab of the level and it opens up, then place the loco in the desired block.**__ \\
 +
 + \\
 +
 +===== From block to block  =====
 +
 +==== Left mouse button + ctrl + alt: ====
 +If pressing the control+alt keys before dragging will add a block to the trip.\\
 +> **Note:** Multiple same block IDs are not supported in a block trip.
 + 
 +
 +==== Left mouse button: ====
 +Set the destination, or end of block trip, for a train and issue the command "GO".\\
 +
 +
 +==== Left mouse button + ctrl: ====
 +If pressing the control key before dragging it will move a train from one block to the other.\\
 +**Note:** //Does not work on macOS; Use Shift+Alt instead.//\\
 +
 +==== Left mouse button + shift + alt: ====
 +If pressing the shift and alt key before dragging it will move a train from one block to the other.\\
 +**Note:** //Available starting with version 2.1.3066+.//\\
 +
 +==== Left mouse button + shift ====
 +A list of possible schedules will popup if the __**[[:finder:finder-en|Finder]]**__ is active.\\
 +After selecting a schedule the train will get a GO command with the schedule.\\
 +
 +==== Left mouse button + alt: ====
 +If pressing the alt key before dragging will set the pass through block to the train.\\
 +The train will not go into the idle state after reaching this block.\\
 +
 + \\
 +
 +===== Start a loco in a block =====
 +Since the arrival of Drag&Drop the single left mouse click had to be sacrificed. A double click is needed to start a loco in a block.\\