User Tools

Site Tools


loc-calibrate-en

Differences

This shows you the differences between two versions of the page.


Previous revision
loc-calibrate-en [2025/06/01 10:06] (current) – [MV Test] babbel
Line 1: Line 1:
 +======Locomotives: Calibrate======
 +[[:english#objects|{{  :objects.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 +[[english|Content]] -> [[english#objects|Objects]] -> **Locomotives**
 +  *  [[loc-index-en|Index]] | [[loc-gen-en|General]] | [[loc-int-en|Interface]] | [[:loc-speed-en|Speed]] | [[loc-details-en|Details]] | [[loc-fun-en|Functions]] | [[loc-consist-en|Multiple Units]] | [[loc-cv-en|CVs]] | [[loc-bbt-en|BBT]] | [[loc-bat-en|BAT]] | [[loc-sbt-en|SBT]] | **[[loc-calibrate-en|Calibrate]]** | [[loc-shunting-en|Shunting Mode]]
  
 + \\
 +=====Calibrate Tab=====
 +{{:loc:loc-calibrate-en.png?800}}\\
 +
 +
 +
 +===== CV 5, 6 =====
 +The following values are used in case an __**[[:mvtrack-setup-en#calibrate|MVTrack calibrating]]**__ command:
 +
 +====Max. km/h====
 +The max. km/h to use for calibrating.\\
 +If zero the **[[:loc-speed-en#v_max_-_kmh_max_v_rmax|V_Max]]** value on the interface tab is used.\\
 +
 +====Mid. km/h====
 +The **mid km/h** value used for calibration refers to the **medium speed of the decoder**, \\
 +**not** to the V_Mid parameter in the *Speed* tab. \\
 +
 +When using a linear speed curve in the decoder, the mid speed should be set to **half of the maximum speed (max. km/h)**. \\
 +Example: If the maximum speed defined in the decoder is 120 km/h, the mid speed should be set to 60 km/h.
 +
 +====CV 5====
 +The maximum decoder speed CV 5 value range; Check the decoder manual for the correct values.\\
 +====CV 6====
 +The percentage, default 30%, of the calculated CV 5 value to save in CV 6. (CV 6 is the mid decoder speed. Check the decoder manual if CV 6 is supported.)\\ 
 +With the checkbox on the right the POM programming of CV 6 can be enabled or disabled.\\
 +
 + \\
 +====VMax/VMid CV#====
 +These fields can be used if the CV numbers are not NMRA DCC conform.\\ 
 +The second field to the right is an optional index of the CV. Typically for MFX decoders.\\
 +**Note:** //The default NMRA DCC values are used if not set.// \\
 +
 +
 +====Adjust====
 +
 +Correction value from 10 to 150% used during calibration to adjust the difference between CV old and CV. \\
 +With some decoders, this adjustment is necessary to achieve a more accurate approximation of the correct value.
 +
 +====MV Test====
 +
 +Simulation of speed measurement.\\
 +
 +**Caution** Use only in a dummy locomotive, as the CV values ​​are stored in the locomotive.