User Tools

Site Tools


loconet:dtopsw-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

loconet:dtopsw-en [2018/11/12 08:56] (current)
Line 1: Line 1:
 +====== Option Switches ======
 +[[:​english#​interfaces|{{ ​ :​interface.png}}]][[:​english|{{ ​ :​rocrail-logo-35.png}}]] ​
 +[[:​english|Content]] -> [[:​english#​command_stations|Command Stations]] -> **[[:​loconet-en| Digitrax LocoNet]]** ​
 +   * [[:​loconet-cs-en|Command Stations]] | [[:​loconet-interfaces-en|Interfaces]] | [[:​lnfc-en|Fast Clock]] | [[:​loconet-dev-en|Throttles]] | **[[loconet:​dtopsw-en|Option Switches]]** | [[:​locont-wi-en|Wiring]] | [[:​loconet:​transponding-en|Transponding]]
  
 +// \\ // \\
 +Digitrax uses **Option Switches** to setup stationary decoders. They can be set by standard switch commands or with special LocoNet commands.\\
 +Rocrail supports with this dialog reading and writing of Option Switches for the following decoders:
 +  * **BDL16x**: current sensors and transponder receiver
 +  * **DS64**: switches
 +  * **SE8**: switches and signals
 + \\
 +| The target decoder must be set in programming mode before option switches can be changed; See manual. |\\
 +
 + \\
 +===== Option Switches Dialog =====
 +{{:​loconet:​dtopswdlg-en.png}}\\
 +
 + \\
 +==== Address ====
 +This is the board address of the decoder.\\
 +This address cannot be changed with this dialog, you need to check the manual for this.\\ ​
 +
 + \\
 +==== Type ====
 +Select the wanted board type to program.\\
 +
 + \\
 +==== Option Switches List ====
 +Each board type has its own set of option switches as is listed after type selection.\\
 +
 + \\
 +==== Read All ====
 +Read all the option switches from the address and type set for the board.\\ ​
 +
 + \\
 +==== Write All ====
 +Write all the option switches from the address and type set for the board.\\ ​
loconet/dtopsw-en.txt ยท Last modified: 2018/11/12 08:56 (external edit)