mbus:cs3-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mbus:cs3-en [2021/01/12 16:35] – [MBUS CS2/CS3] hermannk | mbus:cs3-en [2022/05/01 10:40] (current) – [Switch/Output] rjversluis | ||
---|---|---|---|
Line 16: | Line 16: | ||
====Communication Type==== | ====Communication Type==== | ||
The preferred way to communicate with the CS3 is by using the TCP type.\\ | The preferred way to communicate with the CS3 is by using the TCP type.\\ | ||
+ | The CS3 TCP port is factory set to 15731, the second port is not utilized.\\ | ||
+ | Classic CS2 UDP communication uses two port numbers, sending (Tx) and receiving (Rx). \\ | ||
+ | If the port entry is set to zero, it is automatically replaced with the default values, 15731 and 15730. \\ | ||
{{: | {{: | ||
- | The CS3 TCP port is factory set to 15731.\\ | + | |
====Overview==== | ====Overview==== | ||
If all went well, the CS3 is listed in the CBUS/MBUS dialog:\\ | If all went well, the CS3 is listed in the CBUS/MBUS dialog:\\ | ||
Line 70: | Line 73: | ||
=====Addressing===== | =====Addressing===== | ||
====Switch/ | ====Switch/ | ||
- | An example for the real switch address **11**: | + | An example for the real switch address **12**: |
|< >| | |< >| | ||
- | ^ Type ^ Address ^ Port ^ Calculation | + | ^ Type ^ Address ^ Port ^ Remark ^ |
- | ^ MADA | 3 | 4 | | + | ^ MADA | 3 | 4 | Not supported! |
- | ^ PADA | 0 | 12 | | + | ^ PADA | 0 | 12 | Same scheme as the display address in the CS2/CS3 GUI. | |
- | ^ FADA | - | - | Not supported! | + | ^ FADA | - | |
\\ | \\ |
mbus/cs3-en.1610465717.txt.gz · Last modified: 2021/01/12 16:35 by hermannk