User Tools

Site Tools


rocnet:sw-servo-setup-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

rocnet:sw-servo-setup-en [2018/11/12 08:56] (current)
Line 1: Line 1:
 +====== RocNetNode Servo Switch Setup ======
 +[[:​english#​command_stations|{{ ​ :​interface.png}}]][[:​english|{{ ​ :​rocrail-logo-35.png}}]][[:​rocnet:​rocnetnode-en|{{ :​rocnet:​rocnet-hw.png}}]]
 +[[:​english|Content]] -> [[:​english#​command_stations|Command Stations]] ->  **[[rocnet:​rocnet-prot-en|RocNet]]** ​
 +  * [[rocnet:​rocnet-prot-en|RocNet Protocol]] | **[[:​rocnet:​rocnetnode-en|RocNetNode]]**
 +    * [[:​rocnet:​rocnetnode-hwsetup-en|RocNetNode Setup]] | [[:​rocnet:​rocnetnode-setup-en|RocNetNode Configuration]] | [[:​rocnet:​rocnetnode-img-en|Installer package]]
 +    * [[:​gca1-pi01-en|GCA-Pi01]] | [[:​gca_pi02-en|GCA-Pi02]] | [[:​gca-pi03-en|GCA-PI03]] | [[:​gca-pi04-en|GCA-PI04]] | [[:​gca-pi05-en|GCA-Pi05]] | [[:​gca-pi06-en|GCA-Pi06]] | [[:​gca107-en|GCA107 Relay board]]
 +
 +
 + \\
 + \\
 +=====The example=====
 +This example shows how to setup a switch controlled by a **[[:​rocnet:​rocnetnode-en|RocNetNode]]** servo including:
 +  * Interface
 +  * Field feedback (Wiring)
 +  * Frog polarisation.
 +
 +
 + \\
 +
 +=====General=====
 +{{:​rocnet:​sw-gen-en.png}}\\
 +
 + \\
 +=====Interface=====
 +Set the bus to the RocNetNode-ID,​ the port type to **Servo** and the address to the channel on which the servo is connected.\\
 +{{:​rocnet:​sw-int-en.png}}\\
 +
 + \\
 +=====Wiring=====
 +The **[[:​rocnet:​rocnetnode-en|RocNetNode]]** wait with generating a 'field event' until the wanted pulse width, position, has been reached.\\
 +| Only set **Use field events** for this servo controlled switch. | The __**[[:​rocnet:​rocnetnode-setup-en#​report1|Channel Report]]**__ option must be activated for this functionality. |
 +| {{:​rocnet:​sw-wiring-en.png}} | {{:​rocnet:​sw-channel-setup-en.png}} |\\
 +
 + \\
 +
 +=====Frog=====
 +Just set the two relay addresses for frog 1.\\
 +These addresses are most likely located on a **[[:​gca_pi02-en|GCA-Pi02]]** in combination with a **[[:​gca107-en|GCA107]]**.\\
 +{{:​rocnet:​sw-frog-en.png}}\\
  
rocnet/sw-servo-setup-en.txt ยท Last modified: 2018/11/12 08:56 (external edit)