User Tools

Site Tools


rocview:cmdrecorder-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

rocview:cmdrecorder-en [2018/11/12 08:56] (current)
Line 1: Line 1:
 +====== Command Recorder ======
 +[[:​english#​rocview|{{ ​ :​viewer.png}}]][[:​english|{{ ​ :​rocrail-logo-35.png}}]]
 +[[:​english|Content]] -> [[:​english#​rocview|Rocview ]]
 +  * **Command recorder**
 + ​\\ ​
 +| //​Menu->​Control->​Command recorder// |
 + \\
 +
 +=====Introduction=====
 +The command recorder can be used to record basic commands send from Rocview to the server.\\
 +{{:​rocview:​cmdrecorder-en.png}}\\
 +
 + \\
 +===== Features =====
 +  * Record commands as text
 +  * Play back
 +  * Export and import
 +  * Modify, insert and delete commands
 +  * Create route command
 +  * Time stamp option; Must be activated before recording is started.
 +====Note====
 +  * Not all commands are supported.
 + \\
 +
 +=====Record a Route=====
 +With the following 10 steps a route can be created:
 +  - Make sure Rocview is online. (Connected with the Rocrail server.)
 +  - Reset all involved blocks from occupancy.
 +  - Start recording.
 +  - Click on the start block. -> Use Shift+Click for choosing the plus block side.
 +  - Click on all needed switches, signals and sensors. \\ To get the wanted command correctly in the route use the context menu instead of a single click to select the right command.
 +  - Click on the destination block. -> Use Shift+Click for choosing the plus block side.
 +  - Optional click on the crossing blocks.
 +  - Stop the recording.
 +  - Optional modify some recorded lines.
 +  - Push the **Route** button.
 +The new route will be shown in the Route Dialog to be able to make some changes or set options if needed.\\
 +After pushing the OK button the recorded route will be send to the Rocrail server will show up in the Route Table. With Cancel the recorded route will be rejected.\\
 + \\
 +**Notes:**
 +  * //Works with Standard and with Staging Blocks.//
 +  * //Steps 5 and 6 may be mixed.//
 +  * //The generated route ID is formatted as: **[from block ID+/-]-[to block ID+/-]**//
 +  * //Pause lines will be ignored.//
 +  * //If some switches and/or signals were left clicked the correct commands can be adjusted in the Route Dialog.//
 +
 + \\
 +
 +=====File format=====
 +<​code>​
 +type,<​id>,<​cmd>​
 +</​code>​
 +Only linefeeds are allowed; No extra carriage return. (DOS/​Windows)\\
 +"​Pause"​ is not a command but is used to wait for the number of seconds between the playback steps.\\
 +
 +====Example====
 +<​code>​
 +fb,​fb3a,​true
 +pause,2
 +fb,​fb3b,​true
 +pause,2
 +sw,sw2,flip
 +</​code>​
  
rocview/cmdrecorder-en.txt ยท Last modified: 2018/11/12 08:56 (external edit)