route-speed-en
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
route-speed-en [2019/01/17 19:29] – layout besra | route-speed-en [2023/06/26 15:34] (current) – rjversluis | ||
---|---|---|---|
Line 3: | Line 3: | ||
[[: | [[: | ||
* [[: | * [[: | ||
- | * [[blocksideroutes-en|Block side routes]] | + | |
Line 9: | Line 9: | ||
- | {{: | + | {{: |
Line 18: | Line 18: | ||
* Selection **Block**: The **[[: | * Selection **Block**: The **[[: | ||
- | * Other selection: The selected speed applies (see table below). This overrides the departure speed from the starting block __and__ the arrival speed in the destination block: The speed applies from the beginning of the route to the **in** of the destination block. | + | * Other selection: The selected speed applies (see table below). |
If the route velocity should be reduced because of switches in turnout position option [[# | If the route velocity should be reduced because of switches in turnout position option [[# | ||
Line 51: | Line 51: | ||
* Loco speed remains unchanged if the actual speed is less than max. KmH. | * Loco speed remains unchanged if the actual speed is less than max. KmH. | ||
- | \\ | + | > **Note:** Max KmH has to be set for using **[[: |
=====Options===== | =====Options===== | ||
====Reduce speed==== | ====Reduce speed==== | ||
Line 80: | Line 81: | ||
The train type is optional but if set it must match.\\ | The train type is optional but if set it must match.\\ | ||
====Class==== | ====Class==== | ||
- | A comma separated list of class names. One must match the train class.\\ | + | A comma separated list of class names. One must match the train/loc class.\\ |
- | This is also optional but must match if set.\\ | + | This is optional but must match if set.\\ |
====Variable==== | ====Variable==== |
route-speed-en.1547749790.txt.gz · Last modified: 2019/01/17 19:29 by besra