stageblock:stagingblocks-en
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | stageblock:stagingblocks-en [2018/11/12 08:56] (current) – created - external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ======Staging Block: Example of Setup====== | ||
+ | [[: | ||
+ | [[: | ||
+ | * [[: | ||
+ | * **[[: | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | =====Staging Yard Plan===== | ||
+ | This example explains how to configure a Staging Block. A Staging Block is a siding that is divided into several short sections of track. This allows Rocrail to store trains of different lengths on one track, one train after another. If the first train from the Staging Block has arrived in the next block, then the trains behind the first one, also move up one position. | ||
+ | The following figure shows a station with 4 sidings. Each siding should be set up as Staging Block with 3 sections. Take, for example Staging Block 1 with a total track length of 3.20m. We want to set up 3 sections, each one meter in length. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | =====Staging Block Detail===== | ||
+ | In this example we split the sections in 10cm and 90cm. (Length depends on the configuration of the rolling stock and locomotive braking curve properties). This Staging Block can now store 3 trains, each with a length of 1m, or a shorter train of 1m and a train of about 1.80 m - which then would occupy 2 sections. | ||
+ | |||
+ | Every Staging Block needs an " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | =====Staging Yard in Rocrail===== | ||
+ | In Rocrail it might look like this track layout. On the right side of the 4 Staging Blocks the " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | =====Staging Block Properties===== | ||
+ | Right mouse click in the Staging Block icon (AB_1) to access the properties. | ||
+ | |||
+ | Under the " | ||
+ | The " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **[[: | ||
+ | |||
+ | =====Staging Block Sections===== | ||
+ | Under the tab " | ||
+ | An identifier must be specified, with the length of the sections and the respective sensors. (Only the first one is shown in detail). | ||
+ | |||
+ | Note: The sections of a Staging Block do not have to be the same length! | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **[[: | ||
+ | |||
+ | =====Staging Block Occupancy===== | ||
+ | If you want to take advantage of the occupancy sensor (green track sections) in order to detect cars left behind, then you need to add other sensors in each " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | The occupancy sensor (for example: be_1_1) needs to be entered in the " | ||
+ | | ||
+ | **[[: | ||
+ | |||
+ | |||
+ | |||
stageblock/stagingblocks-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1