Functie Decoder Algemeen

General



Interface ID

Only set this to the IID you set in the rocrail.ini if your setup has more than one CS connected.


ID

Unique decoder identifier used to address this for programming.

Bus

Command Station dependent value. (Selectrix, BiDiB, CBUS, …)


Address

The decoder address which range depends on the decoder type and underlying Command Station.


Protocol

Some command stations do support multiple protocols; Check the user manual for details.


Protocol version

If the Command Station cannot determine the decoder type itself you must specify the version as listed here ddx-en or found in the SRCP description. Most systems do not use this parameter because it is set directly in the CS or it does only support one version.


Personal Tools