Table des matières → Objets → Pont tournant
Le moteur est controllé par un décodeur de locomotive conçu pour les types courant continu. Les fonctions sorties, lumières avant et arrière sont utilisées pour activer le pont tournant. (cables jaunes)
The center contacts of all turntable rail-clips should be electricaly isolated, or as I did removed, and connected to s88 compatible feedback module. (Those modules accepting also the "red-wire" as input signal.) They should be declared in the plan.xml as the posfb's int the turntable tracks.
<tt id="TT01" addr="80" x="18" y="11" z="1" type="locdec" desc="Bahnbetriebswerk Neustadt"> <track posfb="FB300" nr="12" locfb="FB49" blockid="BL18" desc="Main entrance"/> <track posfb="FB305" nr="42" locfb="FB310" desc="Abstellspur"/> <track posfb="FB304" nr="41" locfb="FB309" desc="Schuppentor 1"/> <track posfb="FB303" nr="40" locfb="FB308" desc="Schuppentor 2"/> <track posfb="FB302" nr="39" locfb="FB307" desc="Schuppentor 3"/> <track posfb="FB301" nr="36" locfb="FB306" desc="Sand Wasser Kohlen"/> </tt>
Those feedbacks are activated by the lips of the turntable bridge center contact rail.
The turntable has 48 steps of 7.5°. The connected tracks are numbered counter-clockwise and track 0 is the 0° of the first quadrant. This is the way the RocGui renders the turntable, and this item can not be rotated.
Position-feedback getter contact.
Position-feedback getter contact wirering.
Position-feedback activator: remove this from one side of the bridge.