no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+======Marklin 6050/6051======
+[[:english#command_stations|{{  :interface.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
+[[english|Content]] -> [[english#command_stations|Command Stations]] ->   **Marklin 6050/6051**
+// \\ // \\
+|  Deprecated and no longer supported!  |\\
+Because of the lack of a direction bit in this ancient protocol some features will probably not work in auto mode.\\
+=====Cable configuration=====
+Interface 6050/6051 to RS232
+| **DIN-6** | **D-SUB-9** | Label |
+| 1 | 3 | Rx |
+| 4 | 2 | Tx |
+| 5 | 8 | CTS |
+| 3 | 5 | Ground |
+**Bridge** on D-SUB-9 side pin: **4 - 6 - 1**
+=====Settings=====
+General Command Station setup dialog:\\
+{{:p50-setup-en.png}}\\
+====Line settings====
+===Baudrate===
+\\
+===Hardware Flow===
+CTS\\
+====Sensors====
+===Number===
+Number of s88 units.
+====Version====
+|< >|
+^ Version ^ Command sleep ^ comment ^
+|  0 |  0ms | |
+|  1 |  10ms | |
+|  2 |  50ms |otherwise cts timeout|
+With version 2, the direction change will skip the preceding speed zero command.\\
+====Switch time====
+Time in ms to wait after the last switch command before a switch off command is send to prevent coil damaged.\\
+Use 1000 (if old and slow magnetic objects)
+ \\
+=====Interface 6023=====
+The 6023 interface must be switched to binary mode for using this protocol; Read section 6 on how to switch to binary mode.\\
+  * {{:marklin:ma6023.pdf}}
+ \\