User Tools
easydcc-en
Differences
This shows you the differences between two versions of the page.
| — |
easydcc-en [2018/11/12 08:56] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== EasyDCC ====== | ||
| + | [[:english#command_stations|{{ :interface.png}}]][[:english|{{ :rocrail-logo-35.png}}]] | ||
| + | [[:english|Content]] -> [[:english#command_stations|Command Stations]] -> **[[:easydcc-en|EasyDCC]]** | ||
| + | \\ | ||
| + | {{http://www.cvpusa.com/images/command_station1.jpg?300}}\\ | ||
| + | |||
| + | EasyDCC CS (Command Station) | ||
| + | \\ | ||
| + | |||
| + | {{http://www.cvpusa.com/images/booster_zmaster5.jpg?300}}\\ | ||
| + | EasyDCC Booster\\ | ||
| + | \\ | ||
| + | |||
| + | |||
| + | \\ | ||
| + | =====Communications===== | ||
| + | * 9600 baud | ||
| + | * no parity | ||
| + | * 1 stop bit | ||
| + | * no handshake | ||
| + | |||
| + | \\ | ||
| + | =====Programming CVs===== | ||
| + | The **[[:pt-en#pt|PT Button]]** must be used to put the EasyDCC in and out programming mode.\\ | ||
| + | |||
| + | |||
| + | \\ | ||
| + | |||
| + | =====Notes===== | ||
| + | * The RS232 port on the CS is not enabled by default. See the EasyDCC manual for instructions. (SETUP 0, Page 144) | ||
| + | \\ | ||
| + | |||
| + | ===== Documentation ===== | ||
| + | * The EasyDCC manual is available at http://www.cvpusa.com/doc_center/6_97_easydcc_manual_web_sec.pdf | ||
easydcc-en.txt ยท Last modified: 2018/11/12 08:56 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
