Content → Command Stations → EasyDCC

EasyDCC CS (Command Station)

EasyDCC Booster

• 9600 baud
• no parity
• 1 stop bit
• no handshake

The PT Button must be used to put the EasyDCC in and out programming mode.

• The RS232 port on the CS is not enabled by default. See the EasyDCC manual for instructions. (SETUP 0, Page 144)

• The EasyDCC manual is available at http://www.cvpusa.com/doc_center/6_97_easydcc_manual_web_sec.pdf