User Tools

Site Tools


gca140-en
no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.


gca140-en [2018/12/26 16:12] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +====== GCA140 Standalone controller for commuter trains ======
  
 +[[english|{{  rocrail-logo-35.png}}]]
 +
 +[[english|Content]] -> [[hardware-en|Hardware]] -> [[hardware-en#locoio|GCA]]
 +  *  [[mgv-overview-en|The GCA Modules]]
 +{{  {{:gca:g-ash03_pict_03.jpg?200}}
 +\\
 +
 +
 +^^^^By Peter Giling ^^^^
 +===== Description =====
 +This unit can only be used with standard analog trains which run on normal 12-16V dc.\\
 +It has maximum 4 stop functions.\\
 +Power supply can be done buy any ac or dc train transformer.\\
 +The communter train wil start slowly to maximum speed, and starts decending slowly when the stop section is reached.\\ 
 +An extra option is using a station somewhere half between the ultimate end stop sections.\\
 +The stop sections are defined by cutting the rail into separate scections.\\
 +These separate section are to be connected to input 1..4 on the board.\\
 +The manual, as referred below is expalining the exact connections\\
 +Only one side needs cuting, ALL IN THE SAME RAILSIDE.\\
 +Adjusting maximum speed and pause times is done by pushbuttons.\\
 +
 +===== Manual =====
 +The -timely only in Dutch-  manual can be downmloaded here.\\
 +
 +{{:gca:manual_gca140_nl.pdf|manual GCA140 Nederlands}}
 +
 +
 +===== Hardware =====
 +|  {{:gca:gca140_orcd_sch.pdf|The schematics}}  |
 +|  {{:gca:gca140_pcb.pdf|The pcb and parts positions}}  |
 +\\
 +===== Firmware =====
 +
 +|  {{:gca:gca140.zip|Program created with Picsimulator IDE}}  |
gca140-en.txt · Last modified: 2018/12/26 16:12 by 127.0.0.1